Nissan Altima (L32) 2007-2012 Service Manual: Low tire pressure warning lamp
stays on
Low Tire Pressure Warning Lamp Stays On When
Ignition Switch Is Turned On
DIAGNOSTIC PROCEDURE
1.CHECK BCM CONNECTORS
1. Turn ignition switch OFF.
2. Disconnect BCM harness connectors.
3. Check terminals for damage or loose connections.
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace damaged parts.
2.CHECK BCM POWER SUPPLY AND GROUND CIRCUITS
Check BCM power supply and ground circuits. Refer to BCS-42, "Diagnosis
Procedure".
Is the inspection result normal?
YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".
NO >> Repair BCM circuits.
Low Tire Pressure Warning Lamp Does Not Come
On When Ignition Switch Is Turned On
DIAGNOSTIC PROCEDURE
1.SELF-DIAGNOSTIC RESULT CHECK
Using CONSULT-III, check display contents of BCM in SELF-DIAGN ...
Low Tire Pressure Warning Lamp Flashes When
Ignition Switch Is Turned On
NOTE:
If low tire pressure warning lamp flashes as shown, the system is normal.
Flash Mode A
• This mode shows transmitt ...
Other materials: Radio
Place the ignition switch in the ACC or ON
position and press the PUSHbutton
to turn the radio on. If you listen to the radio
with the engine not running, the ignition
switch should be placed in the ACC
position.
Radio reception is affected by station signal
strength, distance from radio transmitte ...
Windows
Power windows
WARNING
Make sure that all passengers have
their hands, etc., inside the vehicle
while it is in motion and before closing
the windows. Use the window
lock switch to prevent unexpected
use of the power windows.
To help avoid risk of injury or death
through unintended operation ...
Driving safety precautions
Your NISSAN is designed for both normal
and off-road use. However, avoid driving in
deep water or mud as your NISSAN is
mainly designed for leisure use, unlike a
conventional off-road vehicle.
Remember that 2-Wheel Drive (2WD) models
are less capable than All-Wheel Drive
(AWD) models for rough road ...