Nissan Altima Owners Manual: Manual operation

Fan speed control

Press the fan control buttons manually to
manually control the fan speed.

Press the AUTO button to return to automatic control of the fan speed.

Air recirculation

Press the button to recirculate air recirculation
button to recirculate interior air inside the vehicle. The indicator light on the button will come on.
indicator light on the button will come on.

The air recirculation cannot be activated when the air conditioner is in the defrosting front
defrosting mode or the foot outlet front defrosting and
foot outlet mode.

Fresh air intake

Press the to draw fresh air intake button
to draw outside air into the passenger compartment.

The will come indicator light on the button
will come on.

Air flow control

Pressing the MODE button manually controls air flow and selects the air outlet: vents. — Air flows from center and side
vents.

vents and foot outlets. — Air flows from center and side
vents and foot outlets.

outlets. — Air flows mainly from foot
outlets.

outlets. — Air flows from defroster and foot
outlets.

To turn system off Press the OFF button.

Rear window and outside mirror (if so equipped) defroster switch For more information about the rear window and outside mirror (if so equipped) defroster switch, see “Rear window and outside mirror defroster switch” in the “Instruments and controls” section of this manual.

    Automatic operation
    Cooling and/or dehumidified heating (AUTO) This mode may be used all year round as the system automatically works to keep a constant temperature. Air flow distribution and fan speed are also cont ...

    Operating tips
    ● When the engine coolant temperature and outside air temperature are low, the air flow from the foot outlets may not operate for a maximum of 150 seconds. However, this is not a malfunction ...

    Other materials:

    Rear bumper
    Removal and Installation 1. Rear bumper side brackets 2. Rear bumper supports 3. Rear bumper reinforcement 4. Rear energy absorbing foam 5. Rear bumper fascia A. C205 push pin REMOVAL 1. Remove the LH and RH rear combination lamps. Refer to EXL-260, "Removal and Installation" ...

    P0850 PNP Switch
    Description When the shift lever position is P or N (CVT), Neutral position (M/T), park/neutral position (PNP) switch is ON. ECM detects the position because the continuity of the line (the ON signal) exists. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.INSPECTION START ...

    Front power window switch
    Reference Value TERMINAL LAYOUT PHYSICAL VALUES POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH Wiring Diagram Fail Safe FAIL-SAFE CONTROL Switches to fail-safe control when malfunction is detected in encoder signal that detects up/down speed and direction of door glass. ...