Nissan Altima 2007-2012 Service Manual: None of the power windows can be operated using any switch

Diagnosis Procedure

1. CHECK BCM POWER SUPPLY AND GROUND CIRCUIT

Check BCM power supply and ground circuit.

Refer to BCS-42, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2. CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH POWER SUPPLY AND GROUND CIRCUIT

Check power window switch main power supply and ground circuit.

Refer to PWC-198, "POWER WINDOW MAIN SWITCH : Component Function Check".

Is the inspection result normal? YES >> GO TO 3

NO >> Repair or replace the malfunctioning parts.

3. CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH SERIAL CIRCUIT

Check main power window and door lock/unlock switch serial circuit.

Refer to PWC-198, "POWER WINDOW MAIN SWITCH : Component Function Check".

Is the inspection result normal? YES >> GO TO 4

NO >> Repair or replace the malfunctioning parts.

4. CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH

Check main power window and door lock/unlock switch.

Refer to PWC-198, "POWER WINDOW MAIN SWITCH : Component Function Check".

Is the inspection result normal? YES >> Inspection End.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Driver side power window alone does not operate
    Diagnosis Procedure 1. CHECK POWER WINDOW MOTOR LH Check power window motor LH. Refer to PWC-202, "DRIVER SIDE : Component Function Check". Is the inspection result normal? YES > ...

    Other materials:

    On board diagnostic (OBD) system
    Trouble Diagnosis Introduction CAUTION: • Do not use electrical test equipment on any circuit related to the SRS unless instructed to do so in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harness connectors. • Do not attempt to repair, splice or m ...

    Combination switch input circuit
    Diagnosis Procedure 1. CHECK INPUT 1 - 5 SYSTEM CIRCUIT FOR OPEN 1. Turn the ignition switch OFF. 2. Disconnect the BCM and combination switch. 3. Check continuity between BCM harness connector and combination switch harness connector. Does continuity exist? YES >> GO TO 2 NO ...

    Inspection and adjustment
    ECM RE-COMMUNICATING FUNCTION  Description Performing following procedure can automatically perform re-communication of ECM and BCM, but only when the ECM has been replaced with a new one (*1). *1: New one means an ECM which has never been energized on-board. (In this step, initiali ...