Nissan Altima (L32) 2007-2012 Service Manual: Occupant classification system control unit
Removal and Installation
The occupant classification system control unit, occupant classification system sensor, and sensor mat are an integral part of the front passenger seat cushion and are replaced as an assembly. Refer to SE-29, "PASSENGER SIDE : Disassembly".
Diagnosis sensor unit
Removal and Installation REMOVAL 1. Diagnosis sensor unit harness connector 2. Diagnosis sensor unit shield 3. Diagnosis sensor unit A. Diagnosis sensor unit bolts CAUTION: • Before servi ...Collision diagnosis
For Frontal Collision Check the SRS components using the following table. • After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to SRC- 12, &q ...Other materials:
Front tweeter (coupe)
Description
The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker
amp. amplifies the audio
signals before sending them to the front tweeters using the audio signal
circuits.
Diagnosis Procedure
1.HARNESS CHECK
1. Disconnect BOSE speaker amp. connector B122 and suspec ...
Camshaft valve clearance
Valve Clearance
CHECKING
• Perform inspection as follows after removal, installation or replacement
of camshaft or valve related parts, or if there is unusual
engine conditions regarding valve clearance.
Check valve clearance while engine is cold and not running.
1. Remove the air duct w ...
Air mix door motor
Removal and Installation
AIR MIX DOOR MOTOR - LH
Removal
1. Remove the instrument lower cover LH. Refer to IP-12, "Removal and
Installation".
2. Remove the center console side finisher LH. Refer to IP-12, "Removal and
Installation".
3. Remove the heater and cooling ...