Nissan Altima (L32) 2007-2012 Service Manual: Oil filter
Removal and Installation
REMOVAL
1. Remove the oil filter using Tool.
WARNING:
• Be careful not to get burned, the engine and engine oil
may be hot.
CAUTION:
• When removing, prepare a shop cloth to absorb any oil
leakage or spillage.
• Do not allow engine oil to adhere to the drive belts.
• Completely wipe off any oil that adheres to the engine and
the vehicle.
• The oil filter has a built in pressure relief valve. Use a genuine
NISSAN oil filter or equivalent
INSTALLATION
1. Remove foreign materials adhering to the oil filter installation surface.
2. Apply clean engine oil to the oil seal contact surface of the new
oil filter.
3. Screw the oil filter manually until it touches the installation surface,
then tighten it by 2/3 turn. Or tighten to specification below.
4. Check oil level and add engine oil as necessary. Refer to LU-9.
5. After warming up the engine, check for any engine oil leaks.
Changing Engine Oil
WARNING:
• Be careful not to burn yourself, as the engine oil may be hot.
• Prolonged and repeated contact with used engine oil may cause skin cancer: try
to avoi ...
Removal and Installation
1. Ignition coil
2. Spark plug
3. Rocker cover
REMOVAL
1. Remove the ignition coil. Refer to EM-35, "Removal and Installation".
2. Remove the spark plug w ...
Other materials: Seats
WARNING
Do not ride in a moving vehicle when
the seatback is reclined. This can be
dangerous. The shoulder belt will not
be against your body. In an accident,
you could be thrown into it and receive
neck or other serious injuries.
You could also slide under the lap belt
and receive serious ...
Steering Assist display and
indicators
Steering Assist status indicator/
warning
Displays the status of the Steering Assist by
the color of the indicator/warning
Steering Assist indicator (gray): Steering
Assist standby
Steering Assist indicator (green): Steering
Assist active
Steering Assist indicator (yellow): Steering
Assis ...
System temporarily unavailable
Condition A:
The warning and assist functions of the I-LI
system are not designed to work under the
following conditions:
When you operate the lane change signal
and change the traveling lanes in the direction
of the signal. (The I-LI system
will be deactivated for approximately 2
seconds afte ...