Nissan Altima (L32) 2007-2012 Service Manual: Spark plug
Removal and Installation
1. Ignition coil
2. Spark plug
3. Rocker cover
REMOVAL
1. Remove the ignition coil. Refer to EM-35, "Removal and Installation".
2. Remove the spark plug with a suitable spark plug wrench.
INSPECTION AFTER REMOVAL
• Do not use a wire brush for cleaning the spark plugs. Replace as
necessary.
• If plug is covered with carbon, a spark plug cleaner may be used.
• Checking and adjusting plug gap is not required between change
intervals. If the gap is out of specification, replace the spark plug.
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
REMOVAL
1. Remove the oil filter using Tool.
WARNING:
• Be careful not to get burned, the engine and engine oil
may be hot.
CAUTION:
• When removing, prepare ...
Inspection
1. Visually inspect EVAP vapor lines for improper attachment and for cracks,
damage, loose connections,
chafing and deterioration.
2. Inspect fuel tank filler cap vacuum relief valv ...
Other materials: Sun visors
To block glare from the front, swing
down the main sun visor 1.
To block glare from the side, remove the
main sun visor 2 from the center
mount and swing the visor to the side.
To extend the sun visor, slide in or out as
needed 3.
CAUTION
Do not store the sun visor before returning ...
Installing the spare tire
WARNING
For AWD vehicles - the TEMPORARY USE
ONLY spare tire must be installed to the
rear wheels only. If a front tire is punctured,
install the original rear tire onto
the front wheel, then install the TEMPORARY
USE ONLY spare tire on the rear.
Failure to do so could cause overheating
to the AWD ...
Instrument panel
Vents
Steering wheel switches for audio control*
Vehicle information display controls
Headlight/turn signal switch
Paddle shifters (if so equipped)
Driver supplemental air bag
Horn
Meters and gauges
Warning and indicator lights
Vehicle information display
Wiper and washer switch
Heat ...