Nissan Altima 2007-2012 Service Manual: On-vehicle maintenance

ROAD WHEEL

Inspection

ALUMINUM WHEEL

1. Check tires for wear and improper inflation.

2. Check wheels for deformation, cracks and other damage. If deformed, remove wheel and check wheel runout.

a. Remove tire from aluminum wheel and mount on a tire balance machine.

b. Set dial indicator as shown in the figure.

Wheel runout (Dial indicator value): Refer to WT-70.

STEEL WHEEL

1. Check tires for wear and improper inflation.

2. Check wheels for deformation, cracks and other damage. If deformed, remove wheel and check wheel runout.

a. Remove tire from steel wheel and mount on a tire balance machine.

b. Set two dial indicators as shown in the figure.

c. Set each dial indicator to 0.

d. Rotate wheel and check dial indicators at several points around the circumference of the wheel.

e. Calculate runout at each point as shown below.

f. Select maximum positive runout value and the maximum negative value.

Add the two values to determine total runout.

In case a positive or negative value is not available, use the maximum value (negative or positive) for total runout.

If the total runout value exceeds the limit, replace steel wheel.

Wheel runout : Refer to WT-70.

    Preparation
    Special Service Tool The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here. Commercial Service Tools ...

    Other materials:

    On-vehicle repair
    EVAP CANISTER Exploded View Removal and Installation REMOVAL 1. Lift up the vehicle. 2. Remove EVAP canister fixing bolt. 3. Remove EVAP canister. NOTE: The EVAP canister vent control valve and EVAP canister system pressure sensor can be removed without removing the EVAP caniste ...

    Function information
    Component Part Location ENGINE COMPARTMENT 1. A/C compressor F3 2. Ambient sensor E211 3. Refrigerant pressure sensor E219 4. A/C relay (internal to IPDM E/R) 1. A/C compressor F3 2. Ambient sensor E211 3. Refrigerant pressure sensor E219 4. A/C relay (internal to IPDM E/R) PASSENGER ...

    Programming HomeLink®
    If you have any questions or are having difficulty programming your HomeLink® buttons, refer to the HomeLink® web site at: www.homelink.com or call 1-800-355-3515. NOTE: Place the ignition switch in the ACC position when programming HomeLink®. It is also recommended that a new battery be ...