Nissan Altima (L32) 2007-2012 Service Manual: On-vehicle maintenance
PRE-INSPECTION FOR DIAGNOSTIC
Basic Inspection
BASIC INSPECTION
1.INSPECTION START
1. Check the service history.
2. Check the following parts.
• Fuse/circuit breaker blown.
• Poor connection, open or short circuit of harness connector.
• Battery voltage.
Is the inspection result normal?
YES >> Inspection End.
NO >> Repair or replace the malfunctioning parts.
Diagnosis Procedure
1.REPLACE MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH
Replace main power window and door lock/unlock switch.
Refer to PWC-91, "Removal and Installation". After tha ...
POWER WINDOW MAIN SWITCH
Removal and Installation
REMOVAL
1. Remove the power window main switch finisher (2). Refer to
INT-12, "Removal and Installation".
2. Power window main swit ...
Other materials: LED Daytime Running Lights (DRL)
system
The LED DRL automatically illuminate at
100% intensity when the engine is started
and the parking brake released. The LED
Daytime Running Lights (DRL) operate with
the headlight switch in any position. When
you turn the headlight switch to the
position for full illumination, the LED DRL
illuminate ...
Hazard warning flasher switch
Push the switch on to warn other drivers
when you must stop or park under emergency
conditions. All turn signal lights flash.
WARNING
If stopping for an emergency, be sure
to move the vehicle well off the road.
Do not use the hazard warning flashers
while moving on the highway unless
unusual ...
Rear-facing child restraint installation
using the seat belts
WARNING
The three-point seat belt with Automatic
Locking Retractor (ALR) must be
used when installing a child restraint.
Failure to use the ALR mode will result
in the child restraint not being properly
secured. The restraint could tip over or
be loose and cause injury to a child in a
sudden stop o ...
Power window lock switch does
not function
On-vehicle repair