Nissan Altima (L32) 2007-2012 Service Manual: On-vehicle repair
POWER WINDOW MAIN SWITCH
Removal and Installation
REMOVAL
1. Remove the power window main switch finisher (2). Refer to
INT-12, "Removal and Installation".
2. Power window main switch (1) is removed from power window
main switch finisher (2) using a suitable tool (A).
CAUTION:
Do not fold the pawl of power window main switch finisher.
NOTE:
The same procedure is also performed for front power window and
door lock/unlock switch RH, and rear power window switch (LH &
RH).
INSTALLATION
Installation is in the reverse order of removal.
PRE-INSPECTION FOR DIAGNOSTIC
Basic Inspection
BASIC INSPECTION
1.INSPECTION START
1. Check the service history.
2. Check the following parts.
• Fuse/circuit breaker blown.
• Poor con ...
Other materials: Hood
Pull the hood lock release handle 1 located
below the driver's side instrument
panel; the hood springs up slightly.
To open the hood, push the lever 2 underneath
the front of the hood upwards
with your fingertips as illustrated and
raise the hood.
Remove the support rod from the clamp 3.
...
Operating tips
The sunload sensor, located on the top
center of the instrument panel, helps the
system maintain a constant temperature.
Do not put anything on or around this
sensor.
When the climate system is in automatic
operation and the engine coolant temperature
and outside air temperature are
low, the ...
Warning/Indicator lights (other)
For additional information on warnings
and indicators, see "Vehicle information
display-5 inch (13 cm) Type A" or
"Vehicle information display 7 inch (18 cm)
Type B".
Automatic brake hold
indicator light (white/green)
(if so equipped)
The automatic brake hold indicator light
(white) illuminates whe ...
On-vehicle maintenance
Power window control system LH only anti-pinch-sedan