Nissan Altima 2007-2012 Service Manual: On-vehicle repair
HORN
Removal and Installation
REMOVAL
1. Position aside the front fender protector LH. Refer to EXT-19, "Removal and Installation".
2. Disconnect the horn connectors (A).
3. Remove the horn bracket bolt (B), and remove horn (1) and horn (2) if equipped.
INSTALLATION
Installation is in the reverse order of removal.
Component diagnosis
Wiring Diagram - Coupe
Wiring Diagram - Sedan
...
Power Outtlet
...
Other materials:
Front seat head restraints/headrests
WARNING
● Head restraints/headrests supplement
the other vehicle safety systems. They
may provide additional protection
against injury in certain rear end collisions.
Adjust the head
restraints/headrests properly, as specified
in this section. Check the adjustment
after someone else ...
Center speaker
Description
The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker
amp. amplifies the audio
signals before sending them to the center speaker using the audio signal
circuits.
Diagnosis Procedure
1.HARNESS CHECK
1. Disconnect BOSE speaker amp. connector B121 and center ...
The oil pressure warning lamp does not turn off
Description
The oil pressure warning lamp remains illuminated while the engine is running
(normal oil pressure).
Diagnosis Procedure
1.CHECK OIL PRESSURE WARNING LAMP
Perform IPDM E/R auto active test. Refer to PCS-14, "Diagnosis Description".
Is oil pressure warning lamp illumin ...
