Nissan Altima (L32) 2007-2012 Service Manual: On-vehicle repair
IPDM E/R (INTELLIGENT POWER DISTRIBUTION
MODULE ENGINE ROOM)
Removal and Installation
REMOVAL
1. Disconnect the battery negative terminal.
2. Remove the IPDM E/R cover (1) while pressing the pawl (A) at
the rear end of the IPDM E/R cover (1).
3. Disconnect the harness connectors from the IPDM E/R.
4. While depressing the tabs (A) remove the IPDM E/R (1) from the
vehicle.
INSTALLATION
Installation is in the reverse order of removal.
Precaution for Supplemental Restraint System
(SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER ...
Other materials: Sonar limitations
WARNING
Listed below are the system limitations
for the sonar system. Failure to operate
the vehicle in accordance with these
system limitations could result in serious
injury or death.
The system is deactivated at speeds
above 6 mph (10 km/h). It is reactivated
at lower speeds.
Inclement weath ...
RAB system limitations
WARNING
Listed below are the system limitations
for the RAB system. Failure to follow the
warnings and instructions for proper
use of the RAB system could result in
serious injury or death.
When the vehicle approaches an obstacle
while the accelerator or brake pedal is depressed, the function may ...
System maintenance
The two radar sensors 1 for the BSW and
RCTA systems are located near the rear
bumper. Always keep the area near the radar
sensors clean.
The radar sensors may be blocked by temporary
ambient conditions such as splashing
water, mist or fog.
The blocked condition may also be caused
by objects such ...