Nissan Altima 2007-2012 Service Manual: P1226 TP Sensor
Description
Electric throttle control actuator consists of throttle control motor, throttle position sensor, etc. The throttle position sensor responds to the throttle valve movement.
The throttle position sensor has two sensors. These sensors are a kind of potentiometers which transform the throttle valve position into output voltage, and emit the voltage signal to the ECM. In addition, these sensors detect the opening and closing speed of the throttle valve and feed the voltage signals to the ECM. The ECM judges the current opening angle of the throttle valve from these signals and the ECM controls the throttle control motor to make the throttle valve opening angle properly in response to driving condition.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
TESTING CONDITION: Before performing the following procedure, confirm that battery voltage is more than 10V at idle.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Turn ignition switch OFF, wait at least 10 seconds.
3. Turn ignition switch ON.
4. Repeat steps 2 and 3 for 32 times.
5. Check 1st trip DTC.
Is 1st trip DTC detected? YES >> Go to EC-880, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK ELECTRIC THROTTLE CONTROL ACTUATOR VISUALLY
1. Turn ignition switch OFF.
2. Remove the intake air duct.
3. Check if foreign matter is caught between the throttle valve (1) and the housing.
Is the inspection result normal? YES >> GO TO 2.
NO >> Remove the foreign matter and clean the electric throttle control actuator inside.
2.REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
1. Replace electric throttle control actuator.
2. Go to EC-923, "Special Repair Requirement".
>> INSPECTION END
Special Repair Requirement
1.PERFORM THROTTLE VALVE CLOSED POSITION LEARNING
Refer to EC-565, "THROTTLE VALVE CLOSED POSITION LEARNING : Special Repair Requirement" >> GO TO 2.
2.PERFORM IDLE AIR VOLUME LEARNING
Refer to EC-566, "IDLE AIR VOLUME LEARNING : Special Repair Requirement" >> END
P1225 TP Sensor
Description
Electric throttle control actuator consists of throttle control motor,
throttle position sensor, etc. The throttle position sensor responds to
the throttle valve movement.
The thrott ...
P1421 cold start control
Description
ECM controls ignition timing and engine idle speed when engine is started
with prewarming up condition.
This control promotes the activation of three way catalyst by heating the
c ...
Other materials:
Oil seal
Removal and Installation of Valve Oil Seal
REMOVAL
1. Turn crankshaft until the cylinder requiring new oil seals is at TDC. This
will prevent valve from dropping
into cylinder.
CAUTION:
When rotating crankshaft, be careful to avoid scarring the front cover with the
timing chain.
2. Remove ...
ECU diagnosis
AIR CONDITIONER CONTROL
Reference Value
VALUES ON THE DIAGNOSIS TOOL
TERMINAL LAYOUT
PHYSICAL VALUES
Wiring Diagram - Air Conditioner Control (Manual)
- Coupe
Wiring Diagram - Air Conditioner Control (Manual)
- Sedan
...
High-pressure flexible hose
Removal and Installation for High-Pressure Flexible
Hose
QR25DE
Removal
1. Discharge the refrigerant. Refer to HA-32, "HFC-134a (R-134a) Service
Procedure".
2. Reposition the power steering reservoir out of the way without disconnecting
the hose.
3. Reposition the engine coo ...