Nissan Altima 2007-2012 Service Manual: P1726 electric throttle control system

Description

Electric throttle control actuator consists of throttle control motor, accelerator pedal position sensor, throttle position sensor etc. The actuator sends a signal to the ECM, and ECM sends the signal to TCM with CAN communication.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF.

Then wait at least 10 seconds before performing the next test.

1.CHECK DTC DETECTION

1. Start engine and let it idle for 5 seconds.

2. Perform “SELF-DIAG RESULTS” mode for “TRANSMISSION”.

Is “P1726 ELEC TH CONTROL” detected? YES >> Go to TM-357, "Diagnosis Procedure".

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

Diagnosis Procedure

1.CHECK DTC WITH ECM

1. Turn ignition switch ON.

2. Select “SELF-DIAG RESULTS” mode for “ENGINE”.

Is the inspection result normal? YES >> GO TO 2.

NO >> Check DTC Detected Item. Refer to EC-527, "DTC Index" (for California), EC-1015, "DTC Index" (except for California).

2.CHECK DTC WITH TCM

Perform “SELF-DIAG RESULTS” mode for “TRANSMISSION”.

Is “P1726 ELEC TH CONTROL” detected? YES >> Replace TCM. Refer to TM-430, "Exploded View".

NO >> GO TO 3.

3.DETECT MALFUNCTIONING ITEMS

Check TCM connector pin terminals for damage or loose connection with harness connector.

Is the inspection result normal? YES >> Replace TCM. Refer to TM-430, "Exploded View".

NO >> Repair or replace damaged parts.

    P1723 cvt speed sensor function
    Description The vehicle speed sensor CVT [output speed sensor (secondary speed sensor)] detects the revolution of parking gear and generates a pulse signal. The pulse signal is sent to the TCM, ...

    P1740 lock-up select solenoid valve
    Description • Lock-up select solenoid valve controls lock-up clutch pressure or forward clutch pressure (reverse brake pressure). • When controlling lock-up clutch, the valve is turned OFF ...

    Other materials:

    Trouble diagnosis - specification value
    Description The specification (SP) value indicates the tolerance of the value that is displayed in “SPEC” of “DATA MONITOR” mode of CONSULT-III during normal operation of the Engine Control System. When the value in “SPEC” in “DATA MONITOR” mode is within the SP value, the En ...

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the dr ...

    P0130 A/F Sensor 1
    Description The air fuel ratio (A/F) sensor 1 is a planar one-cell limit current sensor. The sensor element of the A/F sensor 1 is composed an electrode layer, which transports ions. It has a heater in the element. The sensor is capable of precise measurement = 1, but also in the lean and ...