Nissan Altima 2007-2012 Service Manual: Component diagnosis
- U1000 can comm circuit
- U1010 control unit (CAN)
- P0703 stop lamp switch
- P0705 park/neutral position switch
- P0710 CVT fluid temperature sensor
- P0715 input speed sensor (pri speed sensor)
- P0720 vehicle speed sensor cvt (secondary speed sensor)
- P0725 engine speed signal
- P0730 belt damage
- P0740 torque converter clutch solenoid valve
- P0744 A/T TCC S/V function (lock -up)
- P0745 line pressure solenoid valve
- P0746 pressure control solenoid a performance (line pressure solenoid valve)
- P0776 pressure control solenoid B performance (sec pressure solenoid valve)
- P0778 pressure control solenoid B electrical (sec pressure solenoid valve)
- P0826 manual mode switch
- P0840 transmission fluid pressure sensor A (sec pressure sensor)
- P0841 pressure sensor function
- P0868 secondary pressure down
- P1701 transmission control module (power supply)
- P1705 throttle position sensor
- P1722 estm vehicle speed signal
- P1723 cvt speed sensor function
- P1726 electric throttle control system
- P1740 lock-up select solenoid valve
- P1745 line pressure control
- P1777 step motor
- P1778 step motor - function
- Shift position indicator circuit
- Shift lock system
Diagnosis system (TCM)
CONSULT-III Function (TRANSMISSION)
CONSULT-III can display each diagnostic item using the diagnostic test
modes shown below
FUNCTION
WORK SUPPORT MODE
Display Item List
Engine Brake Adjus ...
U1000 can comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excelle ...
Other materials:
On-vehicle repair
POWER WINDOW MAIN SWITCH
Removal and Installation
REMOVAL
1. Remove the power window main switch finisher (2). Refer to
INT-34, "Removal and Installation".
2. Power window main switch (1) is removed from power window
main switch finisher (2) using a suitable tool (A).
CAUTION: ...
B210C starter control relay
Description
Starter control relay, integrated in IPDM E/R, permits the starter relay
operation when in N or P position and
the steering is locked or unlocked. It is installed in parallel with the starter
relay.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210C is displayed with DTC U10 ...
Engine speed signal circuit
Description
• ECM sends engine speed signal to power steering control unit.
Diagnosis Procedure
1.PERFORM ECM SELF-DIAGNOSIS
Perform ECM self-diagnosis.
Is any error system detected?
YES >> Check the error system.
NO >> GO TO 2.
2.CHECK HARNESS BETWEEN ECM AND POWER STEE ...