Nissan Altima 2007-2012 Service Manual: Power steering oil pump
QR25DE : Disassembly and Assembly
The power steering oil pump and pulley is not serviceable and should be replaced as an assembly. For front and rear bracket removal, refer to ST-19, "QR25DE : Removal and Installation".
VQ35DE : Disassembly and Assembly
The power steering oil pump and pulley is not serviceable and should be replaced as an assembly. For front and rear bracket removal, refer to ST-20, "VQ35DE : Removal and Installation".
Steering gear and linkage
Exploded View
1. Outer socket
2. Boot clamp
3. Boot
4. Inner socket
5. Boot clamp
6. SSPS valve (part of gear assembly)
7. Gear assembly
Disassembly
1. Remove outer socket locknut and o ...
Service data and specifications
(SDS)
Steering Wheel
Steering Angle
Steering Column
STEERING COLUMN LENGTH
TILT MECHANISM OPERATING RANGE
Steering Gear
STEERING OUTER SOCKET AND INNER SOCKET
RACK STROKE
Oil Pump
S ...
Other materials:
P0845 transmission fluid pressure
sensor B (pri pressure sensor)
Description
The transmission fluid pressure sensor B (primary pressure sensor) detects
primary pressure of CVT and
sends TCM the signal.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn
igniti ...
P1551, P1552 battery current sensor
Description
The power generation voltage variable control enables fuel consumption to be
decreased by reducing the
engine load which is caused by the power generation of the generator. The
battery current sensor is installed
to the battery cable at the negative terminal. The sensor measures t ...
B2605 PNP switch
Description
BCM confirms the shift position with the following 4 signals.
• CVT selector lever
• P/N position switch
• P position signal from IPDM E/R (CAN)
• P position signal from TCM (CAN)
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2605 is displayed with DTC U1000, first ...