Nissan Altima Owners Manual: Programming trouble-diagnosis
If the HomeLink® does not quickly learn the hand-held transmitter information: ● replace the hand-held transmitter batteries with new batteries.
● position the hand-held transmitter with its battery area facing away from the HomeLink® surface.
● press and hold both the HomeLink® and hand-held transmitter buttons without interruption.
● position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink® surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink® is not programmed within that time, try holding the transmitter in another position – keeping the indicator light in view at all times.
If you have any questions or are having difficulty programming your HomeLink® buttons, refer to the HomeLink® web site at: www.homelink.com or call 1-800-355-3515.
Operating the HomeLink® universal transceiver
The HomeLink® Universal Transceiver, after it is
programmed, can be used to activate the programmed
device. To operate, simply press and
release the appropriate programmed
HomeLink® Universal Tr ...
Clearing the programmed information
The following procedure clears the programmed
information from both buttons. Individual buttons
cannot be cleared. However, individual buttons
can be reprogrammed. See “Reprogramming a
single Ho ...
Other materials:
Passenger side
Description
Main power window and door lock/unlock switch, power window and door
lock/unlock switch RH and BCM
transmit and receive the signal by power window serial link.
The signal mentioned below is transmitted from BCM to main power window and door
lock/unlock switch and
power window a ...
Consult-iii checking system
Description
• When CONSULT-III is connected with a data link connector
equipped on the vehicle side, it will communicate with the control
unit equipped in the vehicle and then enable various kinds of diagnostic
tests.
1 : Hood release handle
2 : Data link connector
• Refer to “CONSU ...
During a call
While a call is active, press the
button to
access additional options. Speak one of the following
commands:
● “Send” – Speak this command followed by
the digits to enter digits during the phone
call.
● “Mute On” or “Mute Off” – Speak the command
to mute or unmu ...