Nissan Altima 2007-2012 Service Manual: Push button ignition switch

Removal and Installation

REMOVAL

1. Remove the cluster lid A assembly. Refer to IP-12, "Removal and Installation".

2. Release the pawls (A) and remove the push-button ignition switch (1) from cluster lid A.

INSTALLATION

Installation is in the reverse order of removal.

    Key slot
    Removal and Installation REMOVAL 1. Remove the instrument lower panel LH. Refer to IP-12, "Removal and Installation". 2. Disconnect key slot connector. 3. Remove the key slot scre ...

    Other materials:

    Audio system (sedan)
    System Diagram System Description AUDIO SYSTEM The audio system consists of the following components • Audio unit • Window antenna • Steering wheel audio control switches • Front door speakers • Tweeters • Rear speakers When the audio system is on, radio signals are received ...

    Service data and specifications (SDS)
    General Specification CAUTION: • Use only Genuine NISSAN CVT Fluid NS-2. Do not mix with other fluid. • Using CVT fluid other than Genuine NISSAN CVT Fluid NS-2 will deteriorate in driveability and CVT durability, and may damage the CVT, which is not covered by the NISSAN new vehicle l ...

    Both side headlamps (LO) are not turned on
    Description The headlamps (both sides) do not turn ON in any lighting switch setting. Diagnosis Procedure 1.CHECK COMBINATION SWITCH Check the combination switch. Refer to BCS-10, "System Description". Is the combination switch normal? YES >> GO TO 2 NO >> Repair or r ...