Nissan Altima 2007-2012 Service Manual: On-vehicle repair

Nissan vehicle immobilizer systemnats symptoms
Symptom Table Security indicator does not turn ON or flash. CAUTION: • Follow Trouble Diagnosis Flowchart referring to “SEC-10, "Work Flow"”. Determine malfunctioning condition b ...

Key slot
Removal and Installation REMOVAL 1. Remove the instrument lower panel LH. Refer to IP-12, "Removal and Installation". 2. Disconnect key slot connector. 3. Remove the key slot scre ...

Other materials:

Headlamp (HI) circuit
Description The IPDM E/R (intelligent power distribution module engine room) controls the headlamp high relay based on inputs from the BCM over the CAN communication lines. When the headlamp high relay is energized, power flows through fuses 48 and 49, located in the IPDM E/R. Power then flo ...

B2617 Starter relay circuit
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2617 is display ...

Roof side molding
Removal and Installation 1. Body side outer panel 2. Windshield 2. Windshield REMOVAL 1. Lift and twist the roof side molding up from the rear edge. 2. Disconnect the roof side molding from the clips, and remove the roof side molding. INSTALLATION Installation is in the reverse or ...