Nissan Altima 2007-2012 Service Manual: Rear RH
Description
Door glass moves UP/DOWN by receiving the signal from main power window and door lock/unlock switch or rear power window switch RH.
Component Function Check
1. CHECK POWER WINDOW MOTOR CIRCUIT
Does rear power window motor RH operate with operating power window main switch or rear power window switch RH? Is the inspection result normal? YES >> Power window motor is OK.
NO >> Refer to PWC-119, "REAR RH : Diagnosis Procedure".
Diagnosis Procedure
Rear Power Window Motor RH Circuit Check
1. CHECK REAR POWER WINDOW SWITCH RH OUTPUT SIGNAL
1. Disconnect rear power window motor RH.
2. Turn ignition switch ON.
3. Check voltage between rear power window motor RH connector and ground.
Is the measurement value within the specification? YES >> GO TO 2
NO >> Check rear power window switch RH. Refer to PWC-120, "REAR RH : Component Inspection".
2. CHECK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect rear power window switch RH.
3. Check continuity between rear power window switch RH connector (A) and rear power window motor RH connector (B).
4. Check continuity between rear power window switch RH connector (A) and ground.
Is the inspection result normal? YES >> GO TO 3
NO >> Repair or replace harness.
3. CHECK REAR POWER WINDOW MOTOR RH
Check rear power window motor RH.
Refer to PWC-120, "REAR RH : Component Inspection".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Replace rear power window motor RH. Refer to GW-14, "Removal and Installation".
Component Inspection
1. CHECK REAR POWER WINDOW MOTOR RH
Does motor operate by connecting the battery voltage directly to rear power window motor RH?
Is the inspection result normal? YES >> Power window motor is OK.
NO >> Replace rear power window motor RH. Refer to GW-14, "Removal and Installation".
Rear LH
Description
Door glass moves UP/DOWN by receiving the signal from main power window and
door lock/unlock switch or
rear power window switch LH.
Component Function Check
1. CHECK REAR POWER ...
Encoder
DRIVER SIDE
Description
Detects condition of the front power window motor LH operation and transmits
to main power window and door
lock/unlock switch as pulse signal.
Component Function ...
Other materials:
Can communication circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CONNECTOR INSPECTION
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Disconnect all the unit connectors on CAN communication system.
4. Check terminals and connectors for damage, bend and loose con ...
Getting started
The following procedures will help you get
started using the Bluetooth® Hands-Free Phone
System with NISSAN Voice Recognition. For additional
command options, refer to “List of voice
commands” in this section.
Choosing a language
You can interact with the Bluetooth® Hands-
Free Phone ...
P0037, P0038 HO2S2 heater
Description
SYSTEM DESCRIPTION
The ECM performs ON/OFF control of the heated oxygen sensor 2 heater
corresponding to the engine speed,
amount of intake air and engine coolant temperature.
OPERATION
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Con ...