Nissan Altima (L32) 2007-2012 Service Manual: Service data and specifications (SDS)
General Specification (Rear)
Rear Wheel Alignment (Unladen*)
*: Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions.
*: Fuel, engine coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions.
Ball Joint
Wheelarch Height (Unladen*1)
*1: Fuel, engine coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions.
SEDAN (VQ35DE)
*1: Fuel, engine coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions.
*1: Fuel, engine coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions.
Suspension ARM
Removal and Installation Removal 1. Remove the rear suspension assembly. Refer to RSU-12, "Removal and Installation". 2. Remove the connecting rod bracket from the suspension arm usin ...Other materials:
Main line between DLC and ABS circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (connector side
and harness side).
- Harness co ...
Throttle valve closed position learning
Description
Throttle Valve Closed Position Learning is a function of ECM to learn the
fully closed position of the throttle
valve by monitoring the throttle position sensor output signal. It must be
performed each time the harness connector
of electric throttle control actuator or ECM ...
BCM (Body control module)
Reference Value
VALUES ON THE DIAGNOSIS TOOL
Terminal Layout
Physical Values
1: Sedan only
2: With LH front window anti-pinch
3: With LH and RH front window anti-pinch
4: With Intelligent Key
5: Without Intelligent Key
Wiring Diagram - ENGIN ...