Nissan Altima (L32) 2007-2012 Service Manual: Spark plug
Removal and Installation
1. Ignition coil
2. Spark plug
3. Rocker cover RH
4. Rocker cover LH
REMOVAL
1. Remove the ignition coil. Refer to EM-145, "Removal and Installation LH"
and EM-145, "Removal and
Installation RH".
2. Remove the spark plug with a suitable spark plug wrench.
INSPECTION AFTER REMOVAL
• Do not use a wire brush for cleaning the spark plugs. Replace as
necessary.
• If plug is covered with carbon, a spark plug cleaner may be used.
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
REMOVAL
1. Remove the engine undercover.
2. Remove the oil filter using Tool (A) as shown.
WARNING:
• Be careful not to get burned, the engine and engine oil
ma ...
Inspection
1. Visually inspect EVAP vapor lines for improper attachment and for cracks,
damage, loose connections,
chafing and deterioration.
2. Inspect fuel tank filler cap vacuum relief v ...
Other materials: RearView Monitor system limitations
WARNING
Listed below are the system limitations
for RearView Monitor. Failure to operate
the vehicle in accordance with
these system limitations could result in
serious injury or death.
The system cannot completely eliminate
blind spots and may not show
every object.
Underneath the bumper and t ...
Programming HomeLink
If you have any questions or are having
difficulty programming your HomeLink
buttons, refer to the HomeLink website at:
www.homelink.com or call 1-800-355-3515.
NOTE:
Place the ignition switch in the ON position
(without starting the engine) when
programming HomeLink. It is also recommended that
ane ...
Jacking up vehicle and replacing
the damaged tire (AWD models)
WARNING
For AWD vehicles - the TEMPORARY USE
ONLY spare tire must be installed to the
rear wheels only. If a front tire is punctured,
install the original rear tire onto
the front wheel, then install the TEMPORARY
USE ONLY spare tire on the rear.
Failure to do so could cause overheating
to the AWD ...