Nissan Altima (L32) 2007-2012 Service Manual: Steering column
Disassembly and Assembly
CAUTION:
• Any time the ignition switch has been disconnected, removed or installed, the
keys must be re-registered
in the BCM. Refer to Consult-III operations IVIS/NVIS.
The steering column assembly is not serviceable and must be replaced as an
assembly.
Exploded View
1. Outer socket
2. Boot clamp
3. Boot
4. Inner socket
5. Boot clamp
6. SSPS valve (part of gear assembly)
7. Gear assembly
Disassembly
1. Remove outer socket locknut and o ...
Other materials: Starting the vehicle
1. After starting the engine, fully depress
the foot brake pedal before moving the
shift lever out of the P (Park) position. The
Continuously Variable Transmission is
designed so the foot brake pedal
MUST be depressed before shifting
from P (Park) to any drive position
while the ignition switch is i ...
Steering Assist temporary
standby
Automatic standby due to driving
operation:
When the driver activates the turn signal,
the Steering Assist is temporarily placed in
a standby mode. (The Steering Assist restarts
automatically when the operating
conditions are met again.)
Automatic standby:
In the following cases, a warning message
i ...
LDW system limitations
WARNING
Listed below are the system limitations
for the LDW system. Failure to follow
the warnings and instructions for
proper use of the LDW system could result
in serious injury or death.
The system will not operate at
speeds below approximately 37 mph
(60 km/h) or if it cannot detect lane
ma ...
Disassembly and assembly
Steering gear and linkage