Nissan Altima 2007-2012 Service Manual: Steering switch
Removal and Installation
REMOVAL
1. Remove the driver airbag module. Refer to SR-5, "Removal and Installation".
2. Remove the steering wheel switch assembly screws (A), then remove the steering wheel switches (1).
INSTALLATION
Installation is in the reverse order of removal.
GPS antenna
Removal and Installation REMOVAL 1. Remove the combination meter. Refer to MWI-176, "Removal and Installation". 2. Remove the navigation audio unit. Refer to AV-437, "Removal an ...Audio antenna (coupe)
Location of Antenna 1. In-line connectors M87, M501 2. AV control unit harness 3. AV control unit 4. Satellite antenna 5. AV control unit antenna feeder 6. Satellite radio antenna feeder 7. ...Other materials:
Accelerator pedal released position
learning
Description
Accelerator Pedal Released Position Learning is a function of ECM to learn
the fully released position of the
accelerator pedal by monitoring the accelerator pedal position sensor output
signal. It must be performed each
time harness connector of accelerator pedal position sensor ...
Can communication circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CONNECTOR INSPECTION
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Disconnect all the unit connectors on CAN communication system.
4. Check terminals and connectors for damage, bend and loose con ...
P1217 engine over temperature
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC P1217 is displayed with DTC UXXXX, first perform the trouble diagnosis
for DTC UXXXX.
• If DTC P1217 is displayed with DTC P0607, first perform the trouble diagnosis
for DTC P0607. Refer
to EC-866, "DTC Logic".
If the cooling ...