Nissan Altima (L32) 2007-2012 Service Manual: The light reminder warning does not sound
Description
Light reminder warning does not sound even though headlamp is illuminated.
Diagnosis Procedure
1. CHECK COMBINATION SWITCH (LIGHT SWITCH) OPERATION
Check that the headlamps operate normally by operating the combination switch
(light switch).
Do they operate normally?
YES >> GO TO 2
NO >> Refer to EXL-4, "Work Flow".
2. CHECK DOOR SWITCH LH SIGNAL CIRCUIT
Perform inspection of the door switch LH signal circuit. Refer to DLK-69,
"Diagnosis Procedure".
Is the inspection result normal?
YES >> GO TO 3
NO >> Repair or replace harness.
3. CHECK DOOR SWITCH LH
Perform a unit inspection for the door switch LH. Refer to DLK-71, "Component
Inspection".
Is the inspection result normal?
YES >> Replace the BCM. Refer to BCS-96, "Removal and Installation".
NO >> Replace the front door switch LH.
Description
• The parking brake warning buzzer sounds continuously during vehicle travel
though the parking brake is
released
• The parking brake warning buzzer does not sound at all even tho ...
Description
• Seat belt warning does not sound even though driver seat belt is not
fastened.
• Seat belt warning sounds even though driver seat belt is fastened.
Diagnosis Procedure
1. CHE ...
Other materials: iPod player operation
Type-A.
Connecting iPod
WARNING
Do not connect, disconnect, or operate
the USB device while driving. Doing so
can be a distraction. If distracted you
could lose control of your vehicle and
cause an accident or serious injury.
CAUTION
Do not force the USB device into the
USB port. Inserting th ...
Avoiding collision and rollover
WARNING
Failure to operate this vehicle in a safe
and prudent manner may result in loss
of control or an accident.
Be alert and drive defensively at all times.
Obey all traffic regulations. Avoid excessive
speed, high speed cornering, or sudden
steering maneuvers, because these driving
practices co ...
Changing engine oil and oil filter
For additional information on engine oil
and oil filter change, refer to the instructions
outlined in this section.
Vehicle set-up
1. Park the vehicle on a level surface and
apply the parking brake.
2. Run the engine until it reaches operating
temperature.
3. Turn the engine off and wait for 15 mi ...