Nissan Altima (L32) 2007-2012 Service Manual: The low washer fluid warning continues displaying, or does not display

Description

• The warning is still displayed even after washer fluid is added.

• The warning is not displayed even though the washer tank is empty.

Diagnosis Procedure

1.CHECK WASHER LEVEL SWITCH SIGNAL CIRCUIT

Check the washer level switch signal circuit. Refer to MWI-51, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair harness or connector.

2.CHECK WASHER LEVEL SWITCH UNIT

Perform a unit check for the washer level switch. Refer to MWI-51, "Component Inspection".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-176, "Removal and Installation".

NO >> Replace washer level switch.

    The parking brake release warning continues displaying, or does not display
    Description • The parking brake warning is displayed while driving the vehicle even though the parking brake is released. • The parking brake warning is not displayed even though driving th ...

    The door open warning continues displaying, or does not display
    Description • The door ajar warning is displayed even though all of the doors and the trunk are closed. • The door ajar warning is not displayed even though a door or the trunk is ajar. ...

    Other materials:

    Symptom diagnosis
    SQUEAK AND RATTLE TROUBLE DIAGNOSES Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any customer' ...

    If your vehicle overheats
    If your vehicle is overheating (indicated by an extremely high temperature gauge reading), or if you feel a lack of engine power, detect abnormal noise, etc. take the following steps. WARNING ● Do not continue to drive if your vehicle overheats. Doing so could cause engine damage or a v ...

    P0138, P0158 HO2S2
    Description The heated oxygen sensor 2, after three way catalyst (manifold), monitors the oxygen level in the exhaust gas on each bank. Even if switching characteristics of the air fuel ratio (A/F) sensor 1 are shifted, the air-fuel ratio is controlled to stoichiometric, by the signal from t ...