Nissan Altima 2007-2012 Service Manual: Transmission control module

Exploded View

1. TCM

2. Bracket

3. Battery

Removal and Installation

REMOVAL

1. Disconnect the battery negative terminal.

2. Remove the fresh air intake tube (upper).

3. Disconnect the TCM harness connector.

4. Remove the TCM (1) from the bracket (2).

• Battery (3)

INSTALLATION

Installation is in the reverse order of removal.

    On-vehicle repair
    ...

    Control device
    Exploded View 1. Control lever knob 2. Lock pin 3. Knob cover 4. Control device selector plate 5. Control device assembly Removal and Installation REMOVAL 1. Remove the center console assemb ...

    Other materials:

    P0715 input speed sensor (pri speed sensor)
    Description The input speed sensor (primary speed sensor) detects the primary pulley revolution speed and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has be ...

    How to follow trouble diagnoses
    Description NOTICE: Trouble diagnoses indicate work procedures required to diagnose problems effectively. Observe the following instructions before diagnosing. • Before performing trouble diagnoses, read the “Work Flow” in each section. • After repairs, re-check that the problem ...

    Headlamp
    Bulb Replacement HEADLAMP CAUTION: • Do not touch the glass of bulb directly by hand. Keep grease and other oily substances away from bulb. Do not touch bulb by hand while it is lit or right after being turned off, burning may result. Removal 1. Disconnect negative battery terminal. 2 ...