Nissan Altima (L33) 2013-2018 Owners Manual: Turn signal switch
Turn signal
1 Move the lever up or down to signal the
turning direction. When the turn is completed,
the turn signal cancels automatically.
Lane change signal
2 To signal a lane change, move the lever up or
down to the point where the indicator light
begins to flash, but the lever does not latch.
The turn signal will flash three times automatically.
Push the “+” button A to increase the brightness
of instrument panel lights when driving at
night.
Push the “-” button B to decrease the brightness
of instrument panel lights when driv ...
To turn the fog lights on, turn the headlight switch
to the position, then turn the fog
light
switch to the position.
To turn the fog lights on with the headlight switch in
the AUTOpositio ...
Other materials: Push-button ignition switch
WARNING
Do not operate the push-button ignition
switch while driving the vehicle except
in an emergency. (The engine will
stop when the ignition switch is
pushed
three consecutive times in quick succession
or the ignition switch is pushed
and held for more than 2 seconds.) If
the engine stops while ...
Programming HomeLink for Canadian
customers and gate openers
Canadian radio-frequency laws require
transmitter signals to "time-out" (or quit)
after several seconds of transmission -
which may not be long enough for
HomeLink to pick up the signal during
training. Similar to this Canadian law, some
U.S. gate operators are designed to "timeout"
in the same mann ...
Jacking up vehicle and removing
the damaged tire (2WD models)
WARNING
Never get under the vehicle while it is
supported only by the jack. If it is necessary
to work under the vehicle,
support it with safety stands.
Use only the jack provided with your
vehicle to lift the vehicle. Do not use
the jack provided with your vehicle
on other vehicles. The ja ...