Nissan Altima (L32) 2007-2012 Service Manual: U1010 control unit (can)
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1. REPLACE BCM
When DTC U1010 is detected, replace BCM.
>> Replace BCM. Refer to BCS-96, "Removal and Installation".
Description
CAN (Controller Area Network) is a serial communication line for real time
applications. It is an on-vehicle multiplex
communication line with high data communication speed and excell ...
Description
BCM performs the ID verification with the steering lock unit and releases the
steering lock if both BCM and
steering lock unit ID are same. BCM starts the communication with the steer ...
Other materials: Installing the spare tire
WARNING
For AWD vehicles - the TEMPORARY USE
ONLY spare tire must be installed to the
rear wheels only. If a front tire is punctured,
install the original rear tire onto
the front wheel, then install the TEMPORARY
USE ONLY spare tire on the rear.
Failure to do so could cause overheating
to the AWD ...
Intelligent Driver Alertness system
operation
For vehicles with the 7 inch (18 cm)
display
For vehicles with the 5 inch (13 cm)
display
If the system detects driver fatigue or that
driver attention is decreasing, the message
"Take a break?" appears in the vehicle
information display and a chime sounds
when the vehicle is driven at speeds abov ...
Intelligent Driver Alertness (I-DA)
system limitations
WARNING
Listed below are the system limitations
for the I-DA system. Failure to operate
the vehicle in accordance with these
system limitations could result in serious
injury or death.
The I-DA system may not operate
properly and may not provide an
alert in the following conditions:
Poor road ...
U1000 can comm circuit
B2013 ID discord, immu-strg