Nissan Altima (L32) 2007-2012 Service Manual ≻ Body control system bcm ≻ Component diagnosis ≻ U1010 control unit (can)

Nissan Altima (L32) 2007-2012 Service Manual: U1010 control unit (can)

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure

1. REPLACE BCM

When DTC U1010 is detected, replace BCM.

>> Replace BCM. Refer to BCS-96, "Removal and Installation".

U1000 can comm circuit

Description Refer to LAN-7, "System Description". DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1. PERFORM SELF DIAGNOSTIC 1. Turn ignition switch ON and wait for 2 second or m ...

U0415 vehicle speed sig

Description U0415 is displayed if any unusual condition is present in the reception status of the vehicle speed signal from the ABS actuator and electric unit (control unit). DTC Logic DTC DET ...

Other materials:

Steering Assist temporary standby
Automatic standby due to driving operation: When the driver activates the turn signal, the Steering Assist is temporarily placed in a standby mode. (The Steering Assist restarts automatically when the operating conditions are met again.) Automatic standby: In the following cases, a warning message i ...

Checking engine oil level
2.0L 4 cylinder (KR20DDET engine model) 1. Park the vehicle on a level surface and apply the parking brake. 2. Start the engine and let it idle until it reaches operating temperature. 3. Turn off the engine. Wait more than 10 minutes for the oil to drain back into the oil pan. 4. Remove the dips ...

Readiness for Inspection/Maintenance (I/M) test
WARNING A vehicle equipped with All-Wheel Drive (AWD) should never be tested using a two wheel dynamometer (such as the dynamometers used by some states for emissions testing), or similar equipment. Make sure you inform the test facility personnel that your vehicle is equipped with AWD before it is ...