Nissan Altima 2007-2012 Service Manual: Component diagnosis
- U1000 can comm circuit
- U1010 control unit (can)
- U0415 vehicle speed sig
- B2562 low voltage
- Power supply and ground circuit
- Combination switch input circuit
- Combination switch output circuit
Air pressure monitor
Diagnosis Description DESCRIPTION During driving, the TPMS receives the signal transmitted from the transmitter installed in each wheel, when the tire pressure becomes low. The control unit (BCM) ...U1000 can comm circuit
Description Refer to LAN-7, "System Description". DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1. PERFORM SELF DIAGNOSTIC 1. Turn ignition switch ON and wait for 2 second or m ...Other materials:
CVT fluid cooler system
Cleaning
Whenever an automatic transaxle is repaired, overhauled, or replaced, the CVT
fluid cooler mounted in the
radiator must be inspected and cleaned.
Metal debris and friction material, if present, can be trapped or become deposit
in the CVT fluid cooler. This
debris can contaminate t ...
Oil pan and oil strainer
Removal and Installation
1. Oil level gauge guide
2. Oil pan, upper
3. Cylinder block
4. Oil filter
5. Oil strainer
6. Drain plug
7. Oil pan, lower
8. Rear plate cover
9. O-ring
A. To oil pan, lower
REMOVAL
WARNING:
To avoid the danger of being scalded, never drain the engine oil when ...
B2193, P1612 chain of ecm-immu
Description
BCM performs the ID verification with ECM that allows the engine to start.
Start the engine if the ID is OK.
ECM prevents the engine from starting if the ID is not registered. BCM starts
the communication with ECM if
ignition switch is turned ON.
DTC Logic
DTC DETECTION LOGI ...