Nissan Altima (L32) 2007-2012 Service Manual ≻ Power distribution system ≻ Component diagnosis ≻ U1010 control unit (CAN)

Nissan Altima (L32) 2007-2012 Service Manual: U1010 control unit (CAN)

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure

1. REPLACE BCM

When DTC U1010 is detected, replace BCM.

>> Replace BCM. Refer to BCS-96, "Removal and Installation".

U1000 can comm circuit

Description Refer to LAN-7, "System Description". DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM SELF DIAGNOSTIC 1. Turn ignition switch ON and wait for 2 second or mo ...

B2553 ignition relay

Description BCM turns ON the following relays to ignition power supply to each ECU when the ignition switch is turned ON. • Ignition relay-1 (inside IPDM E/R) • Ignition relay-2 (inside f ...

Other materials:

Operating ProPILOT Assist
Push the ProPILOT Assist switch A. This turns on the ProPILOT Assist system. A screen is displayed for a period of time that indicates the status of the driving aid functions. AEB with Pedestrian Detection, LDW, and BSW are enabled when the specified driving aid is shaded. I-LI is ...

Parking/parking on hills
WARNING Do not stop or park the vehicle over flammable materials such as dry grass, waste paper or rags. They may ignite and cause a fire. Safe parking procedures require that both the parking brake beset and the transmission placed into P (Park). Failure to do so could cause the vehicle ...

Front power seat adjustment (if so equipped)
Operating tips The power seat motor has an auto-reset overload protection circuit. If the motor stops during operation, wait 30 seconds then reactivate the switch. Do not operate the power seat switch for a long period of time when the engine is off. This will discharge the battery. For add ...