Nissan Altima (L32) 2007-2012 Service Manual: U1010 control unit (CAN)
Description
Refer to LAN-9, "Description".
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
Symptom: Displays “CONTROL UNIT (CAN) [U1010]” as a self-diagnosis result of
AV control unit.
1.CHECK CAN COMMUNICATION
Select “SELF-DIAG RESULTS” mode for “MULTI AV” with CONSULT-III.
>> Go to “LAN system”. Refer to LAN-16, "Trouble Diagnosis Flow Chart".
Description
Refer to AV-240, "System Description".
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
Symptom: Displays “CAN COMM CIRCUIT [U1000]” as a self-diagnosis result of AV ...
Description
Refer to AV-240, "System Description".
DTC Logic
DTC DETECTION LOGIC
...
Other materials: ProPILOT Assist (if so equipped)
WARNING
Failure to follow the warnings and instructions
for proper use of the ProPILOT
Assist system could result in serious
injury or death.
ProPILOT Assist is not a self-driving
system. Within the limits of its capabilities,
as described in this manual, it
helps the driver with certain drivin ...
Fuel gauge
The gauge indicates the approximate fuel
level in the tank.
The gauge may move slightly during braking,
turning, acceleration, or going up or
down hills.
The gauge needle returns to 0 (Empty) after
the ignition switch is placed in the OFF
position.
The low fuel warning message shows in
the vehic ...
System operation
The system informs with a visual and audible
alert of rear obstacles when the shift
lever is in the R (Reverse) position.
The system is deactivated at speeds above
6 mph (10 km/h). It is reactivated at lower
speeds.
The intermittent tone will stop after 3 seconds
when an obstacle is detected by on ...