Nissan Altima (L32) 2007-2012 Service Manual ≻ Security control system coupe ≻ Power supply and ground circuit ≻ Warning lamp

Nissan Altima (L32) 2007-2012 Service Manual: Warning lamp

Description

• Warning lamp is built in combination meter.

• Intelligent Key system malfunction is reported to the driver by the warning lamp illumination.

Component Function Check

1.CHECK FUNCTION

1. Perform “INDICATOR” in the “Active Test” mode with CONSULT-III.

2. Check warning lamp operation.

Is the inspection result normal? YES >> Inspection End.

NO >> Refer to SEC-123, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK “COMBINATION METER.”

Check combination meter function. Refer to MWI-4, "Work Flow".

Is the inspection result is normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

Headlamp

Description Headlamp lighting when theft warning system is alarm phase. Component Function Check 1.CHECK HEADLAMP OPERATION Check if headlamp operate by lighting switch. Does headlamp come on ...

Vehicle security indicator

Description • Vehicle security indicator is built in combination meter. • NVIS (Nissan Vehicle Immobilizer System-NATS) and vehicle security system conditions are indicated by blink or illu ...

Other materials:

Push-button ignition switch
WARNING Do not operate the push-button ignition switch while driving the vehicle except in an emergency. (The engine will stop when the ignition switch is pushed three consecutive times in quick succession or the ignition switch is pushed and held for more than 2 seconds.) If the engine stops while ...

Starting the vehicle
1. After starting the engine, fully depress the foot brake pedal before moving the shift lever out of the P (Park) position. The Continuously Variable Transmission is designed so the foot brake pedal MUST be depressed before shifting from P (Park) to any drive position while the ignition switch is i ...

Vehicle information display warnings and indicators
The following messages may appear in your vehicle information display. Place the key near the start switch This indicator appears when the battery of the Intelligent Key is low and when the Intelligent Key system and the vehicle are not communicating normally. If this appears, touch the ignition s ...