Nissan Altima (L32) 2007-2012 Service Manual ≻ Security control system sedan with intelligent key ≻ Component diagnosis ≻ Warning lamp

Nissan Altima (L32) 2007-2012 Service Manual: Warning lamp

Description

• Warning lamp is built in combination meter.

• Intelligent Key system malfunction is reported to the driver by the warning lamp illumination.

Component Function Check

1.CHECK FUNCTION

1. Perform “INDICATOR” in the “Active Test” mode with CONSULT-III.

2. Check warning lamp operation.

Is the inspection result normal? YES >> Inspection End.

NO >> Refer to SEC-322, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK “COMBINATION METER.”

Check combination meter function. Refer to MWI-4, "Work Flow".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

Headlamp

Description Headlamp lighting when theft warning system is in alarm phase. Component Function Check 1.CHECK HEADLAMP OPERATION Check if headlamps operate by lighting switch. Does headlamp come ...

Vehicle security indicator

Description • Vehicle security indicator is built in combination meter. • NVIS (Nissan Vehicle Immobilizer System-NATS) and vehicle security system conditions are indicated by blink or ill ...

Other materials:

Driving safety precautions
Your NISSAN is designed for both normal and off-road use. However, avoid driving in deep water or mud as your NISSAN is mainly designed for leisure use, unlike a conventional off-road vehicle. Remember that 2-Wheel Drive (2WD) models are less capable than All-Wheel Drive (AWD) models for rough road ...

BSW system limitations
WARNING Listed below are the system limitations for the BSW system. Failure to operate the vehicle in accordance with these system limitations could result in serious injury or death. The BSW system cannot detect all vehicles under all conditions. The radar sensors may not be able to detect and ...

Programming trouble-diagnosis
If the HomeLink does not quickly learn the hand-held transmitter information: Replace the hand-held transmitter batteries with new batteries. Position the hand-held transmitter with its battery area facing away from the HomeLink surface. Press and hold both the HomeLink and hand-held transmi ...