Nissan Altima (L32) 2007-2012 Service Manual: Washer level switch signal circuit
Description
Transmits the washer level switch signal to the combination meter.
Component Function Check
1.COMBINATION METER INPUT SIGNAL
1. Select “METER/M&A” on CONSULT-III.
2. Monitor “WASHER W/L” of “DATA MONITOR” under the following conditions.
>> Inspection End.
Diagnosis Procedure
1.CHECK WASHER LEVEL SWITCH SIGNAL CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect combination meter connector and washer level
switch connector.
3. Check continuity between combination meter harness connector
M24 (A) terminal 29 and washer level switch harness connector
E208 (B) terminal 1.
4. Check continuity between combination meter harness connector
M24 (A) terminal 29 and ground.
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair harness or connector.
2.CHECK WASHER LEVEL SWITCH GROUND CIRCUIT
Check continuity between washer fluid level switch harness connector
E208 terminal 2 and ground.
Is the inspection result normal?
YES >> Inspection End.
NO >> Repair harness or connector.
Component Inspection
1.CHECK WASHER FLUID LEVEL SWITCH
Check continuity between washer level switch terminals 1 and 2.
Is the inspection result normal?
YES >> Inspection End.
NO >> Replace washer level switch.
Description
Transmits the parking brake switch signal to the combination meter.
Component Function Check
1.COMBINATION METER INPUT SIGNAL
1. Select “METER/M&A” on CONSULT-III.
2. Moni ...
Description
Transmits the ambient sensor signal to the combination meter.
Component Function Check
1.COMBINATION METER INPUT SIGNAL
1. Select “METER/M&A” on CONSULT-III.
2. Using “O ...
Other materials: Voice commands
Voice commands can be used to operate
the Bluetooth Hands-Free Phone System.
Press and hold thebutton for less
than 1.5 seconds to bring up the phone
command menu. The commands available
are:
Call <name>
Dial <number>
Recent Calls
Read/Send Text (if so equipped)
Siri (if so equipp ...
BSW system operation
For vehicles with the 7 inch (18 cm) display
Side BSW/RCTA Indicator Light
BSW indicator
The BSW system operates above approximately
20 mph (32 km/h).
If the radar sensors detect a vehicle in the
detection zone, the side BSW/RCTA indicator
light (1) illuminates. If the turn signal is
then acti ...
Turning the RAB system on/off
For vehicles with the 7 inch (18 cm) display
Perform the following steps to turn the RAB
system ON or OFF.
For vehicles with the 7 inch (18 cm) display.
1. Press thebutton until
"Settings" displays
in the vehicle information display.
Use thebutton to select "Driver
Assistance."
Then press the OK ...