Nissan Altima 2007-2012 Service Manual: Air breather hose

Exploded View

1. Air cleaner

2. Air breather hose

3. Transaxle assembly

4. Heater pipe

5. Clip

A. Paint mark

Removal and Installation

CAUTION: • Install air breather hose with paint mark facing front.

• Insert air breather hose onto air breather tube until overlap area reaches the spool.

• Install air breather hose to heater pipe and air cleaner case by fully inserting the clip.

• Make sure there are no pinched or restricted areas on air breather hose caused by bending or winding when installing it.

    Control cable
    Exploded View 1. Control lever 2. Control device assembly 3. Control cable socket 4. Retainer grommet 5. Control cable 6. Bracket 7. Lock plate 8. Manual lever Removal and Installation RE ...

    Differential side oil seal
    Exploded View 1. Transaxle assembly 2. Differential side oil seal Removal and Installation REMOVAL 1. Remove drive shaft assembly. Refer to FAX-11, "Removal and Installation (Left Side) ...

    Other materials:

    Differential side oil seal
    Exploded View 1. Transaxle assembly 2. Differential side oil seal Removal and Installation REMOVAL 1. Remove drive shaft assembly. Refer to FAX-11, "Removal and Installation (Left Side)" and FAX-12, "Removal and Installation (Right Side)". 2. Remove the differential ...

    Cooling system
    Cooling Circuit 1. Thermostat 2. Water control valve 3. Water control valve housing (Water outlet) 4. Cylinder block (Thermostat housing) 5. Water inlet 6. Radiator 7. Water pump 8. Cylinder block 9. Cylinder head A. Open B. Closed C. To electric throttle control D. To oil cooler E. ...

    Cooling fan control
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: The ECM determines the start signal status by the signals of engine speed and battery voltage. *2: This signal is sent to ECM through CAN communication line. SYSTEM DESCRIPTION ECM controls cooling fan speed correspondin ...