Nissan Altima 2007-2012 Service Manual: Control cable
Exploded View
1. Control lever
2. Control device assembly
3. Control cable socket
4. Retainer grommet
5. Control cable
6. Bracket
7. Lock plate
8. Manual lever
Removal and Installation
REMOVAL
1. Shift control lever to "P".
2. Remove the air filter assembly. Refer to EM-25, "Removal and Installation".
3. Remove the control cable nut and control cable from the manual lever.
4. Remove the lock plate and the control cable from the bracket.
5. Remove the center console. Refer to IP-18, "Disassembly and Assembly".
6. Remove the bracket covering the retainer grommet.
7. Remove the retainer grommet bolts and the retainer grommet.
8. Remove the control cable from the control device assembly.
9. Remove the control cable from the vehicle.
INSTALLATION
Installation is in the reverse order of removal.
• When installing the control cable to the control device assembly, make sure that the control cable socket is fully pressed into the control device assembly, and the control cable end is fully pressed in with the ribbed surface facing upward.
• After installation is complete, adjust and check the CVT position. Refer to TM-253, "Inspection and Adjustment".
Control device
Exploded View
1. Control lever knob
2. Lock pin
3. Knob cover
4. Control device selector plate
5. Control device assembly
Removal and Installation
REMOVAL
1. Remove the center console assem ...
Air breather hose
Exploded View
1. Air cleaner
2. Air breather hose
3. Transaxle assembly
4. Heater pipe
5. Clip
A. Paint mark
Removal and Installation
CAUTION:
• Install air breather hose with paint ma ...
Other materials:
IPDM E/R (Intelligent power distribution
module engine room)
Diagnosis Procedure
1. CHECK FUSES AND FUSIBLE LINK
Check that the following IPDM E/R fuses or fusible link are not blown.
Is the fuse blown?
YES >> Replace the blown fuse or fusible link after repairing the affected
circuit.
NO >> GO TO 2
2. CHECK POWER SUPPLY CIRCUIT
1. Tu ...
B2109 steering lock relay
Description
The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN
communication.
IPDM E/R turns the steering lock relay ON and transmits the release of the
steering to BCM.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2109 is displayed with DTC U1000, first per ...
Precaution
Supplemental Restraint System (SRS) "AIR BAG"
and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front ...