Nissan Altima (L32) 2007-2012 Service Manual: Air breather hose
Exploded View
1. Air breather hose
2. Clip
3. Bracket
4. Air breather tube
5. CVT assembly
A. Paint mark
Removal and Installation
Refer to the figure for removal and installation.
CAUTION:
• Install air breather hose with paint mark facing upward.
• Insert air breather hose a minimum of 17mm (0.67 in) onto air breather tube
(to end of air breather
tubes radius end).
• Install air breather hose to bracket by fully inserting the clip.
• Make sure there are no pinched or restricted areas on air breather hose caused
by bending or winding
when installing it.
Exploded View
1. CVT assembly
2. Differential side oil seal
Removal and Installation
REMOVAL
1. Remove drive shaft assembly. Refer to FAX-11, "Removal and
Installation (Left Side)&quo ...
Exploded View
1. Washer
2. Manual lever
3. PNP switch
4. CVT assembly
Removal and Installation
Refer to the figure for removal and installation.
NOTE:
• Align PNP switch position when ...
Other materials: Heater operation
Heating
This mode is used to direct heated air to
the foot outlets. Some air also flows from
the defrost outlets and the side vent
outlets.
1. Press thebutton to the off
position
for normal heating.
2. Press theair flow control
button.
3. Turn thefan speed control dial
to
the desired position.
...
Intelligent Around View Monitor
(if so equipped)
CAMERA button
WARNING
Failure to follow the warnings and instructions
for the proper use of the Intelligent
Around View Monitor system
could result in serious injury or death
The Intelligent Around View Monitor
is a convenience feature and is not a
substitute for proper vehicle operation
be ...
Manual anti-glare rearview mirror
(if so equipped)
Use the night position 1 to reduce glare
from the headlights of vehicles behind you
at night.
Use the day position 2 when driving in
daylight hours.
WARNING
Use the night position only when necessary,
because it reduces rear view
clarity.
Automatic anti-glare rearview mirror
(if so equipped)
The ...