Nissan Altima (L32) 2007-2012 Service Manual ≻ Engine mechanical ≻ On-vehicle repair ≻ Air cleaner and air duct

Nissan Altima (L32) 2007-2012 Service Manual: Air cleaner and air duct

Removal and Installation

1. Air duct hose

2. Duct sub-cover

3. Front air duct

4. Air cleaner assembly

5. Grommets

6. Air cleaner mounting bracket

7. Bracket

8. Mass air flow sensor

A. To electric throttle control actuator

REMOVAL

1. Remove front air duct.

2. Disconnect the tube clamp at the electric throttle control actuator and at the air duct hose.

3. Remove air duct hose.

4. Disconnect mass air flow sensor.

5. Remove mass air flow sensor from air cleaner assembly, as necessary.

CAUTION: Handle mass air flow sensor with care.

• Do not shock it.

• Do not disassemble it.

• Do not touch its sensor.

6. Remove air cleaner assembly.

INSTALLATION

Installation is in the reverse order of removal.

Intake manifold collector

Removal and Installation 1. Power valve (RH) 2. Intake manifold collector 3. Gasket 4. Power valve (LH) 5. Electric throttle control actuator REMOVAL WARNING: • To avoid the danger of bein ...

Other materials:

Child safety
WARNING Do not allow children to play with the seat belts. Most seating positions are equipped with Automatic Locking Retractor (ALR) mode seat belts. If the seat belt becomes wrapped around a child’s neck with the ALR mode activated, the child can be seriously injured or killed if the seat belt r ...

Supplemental air bag warning labels
Warning labels about the supplemental front-impact air bag system are placed in the vehicle as shown in the illustration. WARNING Do not use a rear-facing child restraint on a seat protected by an air bag in front of it. If the air bag deploys, it may cause serious injury or death. Supplemental air ...

Seat belt extenders
If, because of body size or driving position, it is not possible to properly fit the lap/ shoulder belt and fasten it, an extender that is compatible with the installed seat belts is available for purchase. The extender adds approximately 8 in (200 mm) of length and may be used for either the driver ...