Nissan Altima 2007-2012 Service Manual: On-vehicle repair
- Air cleaner and air duct
- Intake manifold collector
- Intake manifold
- Exhaust manifold and three way catalyst
- Oil pan and oil strainer
- Ignition coil
- Fuel injector and fuel tube
- Rocker cover
- Front timing chain case
- Timing chain
- Rear timing chain case
- Camshaft
- Oil seal
- Cylinder head
Compression pressure
On-Vehicle Service
CHECKING COMPRESSION PRESSURE
1. Run the engine until it reaches normal operating temperature.
2. Turn the ignition switch to OFF.
3. Release fuel pressure and leave the fue ...
Air cleaner and air duct
Removal and Installation
1. Air duct hose
2. Duct sub-cover
3. Front air duct
4. Air cleaner assembly
5. Grommets
6. Air cleaner mounting bracket
7. Bracket
8. Mass air flow sensor
A. To el ...
Other materials:
P0452 evap control system pressure
sensor
Description
The EVAP control system pressure sensor detects pressure in the
purge line. The sensor output voltage to the ECM increases as pressure
increases.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously condu ...
Service information for electrical
incident
Work Flow
Control Units and Electrical Parts
PRECAUTIONS
• Never reverse polarity of battery terminals.
• Install only parts specified for a vehicle.
• Before replacing the control unit, check the input and output and functions of
the component parts.
• Do not apply excessi ...
Clearing the programmed information
The following procedure clears the programmed
information from both buttons. Individual buttons
cannot be cleared. However, individual buttons
can be reprogrammed. See “Reprogramming a
single HomeLink® button” in this section.
To clear all programming:
1. Press and hold the two outer Ho ...