Nissan Altima (L32) 2007-2012 Service Manual ≻ Audio, visual & navigation system bose audio with navigation ≻ On-vehicle repair ≻ Antenna AMP

Nissan Altima (L32) 2007-2012 Service Manual: Antenna AMP

Removal and Installation - Coupe

REMOVAL

1. Remove the rear pillar finisher RH. Refer to INT-20, "Exploded View".

2. Detach the antenna amp harness clip (B), disconnect the antenna amp connectors (A), remove the antenna amp screw (C) and remove the antenna amp (1).

INSTALLATION

Installation is in the reverse order of removal.

Removal and Installation - Sedan

REMOVAL

1. Remove the rear pillar finisher RH. Refer to INT-42, "Exploded View".

2. Partially remove the side curtain air bag module RH to gain access to the antenna amp. Refer to SR-12, "Removal and Installation".

3. Detach the antenna amp harness clip (A), disconnect the antenna amp connectors (B), remove the antenna amp screw (C) and remove the antenna amp (1).

INSTALLATION

Installation is in the reverse order of removal.

Audio antenna (sedan)

Location of Antenna 1. In-line connectors M87, M501 2. AV control unit harness 3. AV control unit 4. Satellite antenna 5. AV control unit antenna feeder 6. Satellite radio antenna feeder 7. ...

Microphone

Removal and Installation REMOVAL 1. Remove the room/map lamp assembly. Refer to INL-121, "Removal and Installation". 2. Detach the microphone connector (A). 3. Remove the map lamp ...

Other materials:

Headlight control switch
Type A (if so equipped) Lighting Rotate the switch to the position, and the front parking, tail, license plate, and instrument panel lights will come on. The will illuminate in the meter. Rotate the switch to the position, and the headlights will come on and all the other lights re ...

MOD system operation
The MOD system will turn on automatically under the following conditions: When the shift lever is in the R (Reverse) position. When the CAMERA button is pressed to activate the camera view on the display. When vehicle speed decreases below approximately 6 mph (10 km/h) and the camera screen ...

Changing engine oil and oil filter
For additional information on engine oil and oil filter change, refer to the instructions outlined in this section. Vehicle set-up 1. Park the vehicle on a level surface and apply the parking brake. 2. Run the engine until it reaches operating temperature. 3. Turn the engine off and wait for 15 mi ...