Nissan Altima 2007-2012 Service Manual: Auto operation does not operate but manual operates normally (driver side)

Nissan Altima 2007-2012 Service Manual / Power window control system lh&rh front anti-pinch-sedan / Symptom diagnosis / Auto operation does not operate but manual operates normally (driver side)

Diagnosis Procedure

1. PERFORM INITIALIZATION PROCEDURE

Perform initialization procedure.

Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2. CHECK ENCODER

Check encoder.

Refer to PWC-320, "DRIVER SIDE : Component Function Check".

Is the inspection result normal? YES >> Inspection end.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Anti-pinch system does not operate normally (passenger side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement&qu ...

    Auto operation does not operate but manual operates normally (passenger side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement&quo ...

    Other materials:

    Accelerator pedal released position learning
    Description Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time harness connector of accelerator pedal position sensor ...

    Blower motor
    Description SYSTEM DESCRIPTION Component Parts Fan speed control system components are: • Front air control • A/C LAN system (PBR built-in mode door motor, air mix door motor and intake door motor) System Operation Component Function Check INSPECTION FLOW 1. CONFIRM SYMPTOM BY PERF ...

    Symptom diagnosis
    SQUEAK AND RATTLE TROUBLE DIAGNOSES Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any customer' ...