Nissan Altima 2007-2012 Service Manual: Symptom diagnosis
- None of the power windows can be operated using any switch
- Driver side power window alone does not operate
- Front passenger side power window alone does not operate
- Rear lh side power window alone does not operate
- Rear rh side power window alone does not operate
- Anti-pinch system does not operate normally (driver side)
- Anti-pinch system does not operate normally (passenger side)
- Auto operation does not operate but manual operates normally (driver side)
- Auto operation does not operate but manual operates normally (passenger side)
- Power window retained power operation does not operate properly
- Does not operate by key cylinder switch
- Keyless power window down does not operate
- Power window lock switch does not function
Precaution
Precaution for Supplemental Restraint System
(SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER ...
None of the power windows can be
operated using any switch
Diagnosis Procedure
1. CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Check BCM power supply and ground circuit.
Refer to BCS-42, "Diagnosis Procedure".
Is the inspection result normal?
...
Other materials:
Sound signal circuit (sedan)
SATELLITE RADIO TUNER
Description
Left and right channel audio signals are supplied from the satellite radio
tuner to the audio unit through the
sound signal circuits.
Diagnosis Procedure
LEFT CHANNEL
1.CHECK HARNESS
1. Turn ignition switch OFF.
2. Disconnect satellite radio tune ...
P1225 TP Sensor
Description
Electric throttle control actuator consists of throttle control motor,
throttle position sensor, etc. The throttle position sensor responds to
the throttle valve movement.
The throttle position sensor has two sensors. These sensors are a
kind of potentiometers which transform the ...
U1000 can comm circuit
Description
Refer to LAN-7, "System Description".
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.PERFORM SELF DIAGNOSTIC
1. Turn ignition switch ON and wait for 2 second or more.
2. Check “Self Diagnostic Result”.
Is “CAN COMM CIRCUIT” displayed?
YES >> ...