Nissan Altima (L32) 2007-2012 Service Manual ≻ Power window control system lh&rh front anti-pinch-sedan ≻ Symptom diagnosis ≻ Auto operation does not operate but manual operates normally (passenger side)

Nissan Altima (L32) 2007-2012 Service Manual: Auto operation does not operate but manual operates normally (passenger side)

Diagnosis Procedure

1. PERFORM INITIALIZATION PROCEDURE

Perform initialization procedure.

Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2. CHECK ENCODER

Check encoder.

Refer to PWC-322, "PASSENGER SIDE : Component Function Check".

Is the inspection result normal? YES >> Inspection end.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

Auto operation does not operate but manual operates normally (driver side)

Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement&qu ...

Power window retained power operation does not operate properly

Diagnosis Procedure 1. CHECK FRONT DOOR SWITCH Check front door switch. Refer to PWC-326, "Component Function Check". Is the inspection result normal? YES >> Inspection end. ...

Other materials:

Programming HomeLink for Canadian customers and gate openers
Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission - which may not be long enough for HomeLink to pick up the signal during training. Similar to this Canadian law, some U.S. gate operators are designed to "timeout" in the same mann ...

Supplemental air bag warning labels
Warning labels about the supplemental front-impact air bag system are placed in the vehicle as shown in the illustration. WARNING Do not use a rear-facing child restraint on a seat protected by an air bag in front of it. If the air bag deploys, it may cause serious injury or death. Supplemental air ...

System maintenance
The two radar sensors 1 for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog. The blocked condition may also be caused by objects such ...