Nissan Altima (L32) 2007-2012 Service Manual: B2191, P1615 difference of key
Description
Performs ID verification through BCM and Intelligent Key when push-button
ignition switch is pressed.
Prohibits the release of steering lock or start of engine when an unregistered
ID of Intelligent Key is used.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Press the push-button ignition switch.
2. Check “Self Diagnostic Result” with CONSULT-III.
Is DTC detected?
YES >> Refer to SEC-266, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.PERFORM INITIALIZATION
Perform initialization with CONSULT-III. Re-register all Intelligent Keys.
For initialization and registration of Intelligent Key, refer to “CONSULT-III
Operation Manual.
Can the system be initialized and can the engine be started with re-registered
Intelligent Key?
YES >> ID was unregistered.
NO >> BCM is malfunctioning.
• Replace BCM. Refer to BCS-96, "Removal and Installation".
• Perform initialization again.
• Replace ECM.
Description
Performs ID verification through BCM and Intelligent Key when push-button
ignition switch is pressed.
Prohibits the release of steering lock or start of engine when an unregistered
...
Description
BCM performs the ID verification with ECM that allows the engine to start.
Start the engine if the ID is OK.
ECM prevents the engine from starting if the ID is not registered. BCM st ...
Other materials: Front power seat adjustment
(if so equipped)
Operating tips
The power seat motor has an auto-reset
overload protection circuit. If the motor
stops during operation, wait 30 seconds
then reactivate the switch.
Do not operate the power seat switch for
a long period of time when the engine is
off. This will discharge the battery.
For add ...
Settings
The setting mode allows you to change the
information displayed in the vehicle information
display. It also allows you to change
vehicle functions:
VDC
Driver Assistance
Clock
Meter Settings
Vehicle Settings
Maintenance
Alarm
Tire Pressures
Unit
Language
Factory Reset
VDC
The VDC Settin ...
Precautions on seat belt usage
If you are wearing your seat belt properly
adjusted and you are sitting upright and
well back in your seat with both feet on the
floor, your chances of being injured or killed
in a collision and/or the severity of injury
may be greatly reduced. NISSAN strongly
encourages you and all of your passeng ...