Nissan Altima 2007-2012 Service Manual: B2192, P1611 ID discord, IMMU-ECM

Description

BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK.

ECM prevents the engine from starting if the ID is not registered. BCM starts the communication with ECM if ignition switch is turned ON.

DTC Logic

DTC DETECTION LOGIC

NOTE: • If DTC B2192 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-235, "DTC Logic".

• If DTC B2192 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-236, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON under the following conditions: - CVT selector lever is in the P or N position.

- Do not depress the brake pedal.

2. Check “Self Diagnostic Result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-267, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.PERFORM INITIALIZATION

Perform initialization with CONSULT-III. Re-register all Intelligent Keys.

For initialization and registration of Intelligent Key, refer to “CONSULT-III Operation Manual.

Can the system be initialized and can the engine be started with re-registered Intelligent Key? YES >> ID was unregistered.

NO >> BCM is malfunctioning.

• Replace BCM. Refer to BCS-96, "Removal and Installation".

• Perform initialization again.

• Replace ECM.

    B2191, P1615 difference of key
    Description Performs ID verification through BCM and Intelligent Key when push-button ignition switch is pressed. Prohibits the release of steering lock or start of engine when an unregistered ...

    B2193, P1612 chain of ECM-IMMU
    Description BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK. ECM prevents the engine from starting if the ID is not registered. BCM s ...

    Other materials:

    Audio antenna (sedan)
    Location of Antenna 1. In-line connectors M87, M501 2. Audio unit harness 3. Audio unit 4. Satellite antenna 5. Audio antenna feeder 6. Satellite radio antenna feeder 7. Window Antenna 8. Antenna amp. 9. Satellite radio tuner Window Antenna Repair ELEMENT CHECK 1. Attach probe circuit ...

    Fuel pressure
    Inspection FUEL PRESSURE RELEASE 1. Turn ignition switch ON. 2. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode with CONSULT-III. 3. Start engine. 4. After engine stalls, crank it 2 or 3 times to release all fuel pressure. 5. Turn ignition switch OFF. 1. Remove fuel ...

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the dr ...