Nissan Altima 2007-2012 Service Manual: B2556 push-button ignition switch

Description

The switch that changes the power supply position. BCM maintains the power supply position status. BCM changes the power supply position with the operation of the push-button ignition switch.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Start the engine and wait for at least 100 seconds.

2. Check “Self Diagnostic Result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-463, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK PUSH-BUTTON IGNITION SWITCH INPUT SIGNAL

1. Turn ignition switch OFF.

2. Disconnect push-button ignition switch harness connector.

3. Check voltage between push-button ignition switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 2

NO >> GO TO 4

2.CHECK PUSH-BUTTON IGNITION SWITCH

Refer to SEC-464, "Component Inspection".

Is the inspection result normal? YES >> GO TO 3

NO >> Replace push-button ignition switch. Refer to SEC-597, "Removal and Installation".

3.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

4.CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT FOR SHORT

1. Disconnect BCM harness connector and IPDM E/R harness connector.

2. Check continuity between push-button ignition switch harness connector and ground.

Is the inspection result normal? YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".

NO >> Repair harness or connector.

Component Inspection

1.CHECK PUSH-BUTTON IGNITION SWITCH

1. Turn ignition switch OFF.

2. Disconnect push-button ignition switch harness connector.

3. Check continuity between push-button ignition switch terminals under the following conditions.

Is the inspection result normal? YES >> Inspection End.

NO >> Replace push-button ignition switch. Refer to SEC-597, "Removal and Installation".

    B2555 stop lamp
    Description BCM detects the stop lamp status and confirms the stop lamp switch ON/OFF status. BCM confirms the engine start condition according to the stop lamp switch ON/OFF status. DTC Logic ...

    B2557 vehicle speed
    Description BCM receives the 2 vehicle speed signals via CAN communication. One signal is transmitted by the “unified meter”. Another signal is transmitted by “ABS actuator and electric unit ...

    Other materials:

    C1712 - C1715, C1720 - C1723, C1724 -C1727 Transmitter malfunction
    Description One or more transmitters are malfunctioning internally. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.DRIVE VEHICLE 1. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes. 2. Check all tire pressu ...

    Anti-pinch system does not operate normally (driver side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement". Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace the mal ...

    P2100, P2103 Throttle control motor relay
    Description Power supply for the throttle control motor is provided to the ECM via the throttle control motor relay. The throttle control motor relay is controlled ON/OFF by the ECM. When the ignition switch is turned ON, the ECM sends an ON signal to throttle control motor relay and battery ...