Nissan Altima 2007-2012 Service Manual: B2560 starter control relay

Description

Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the starter relay.

DTC Logic

DTC DETECTION LOGIC

NOTE: • If DTC B2560 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-433, "DTC Logic".

• If DTC B2560 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-434, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON under the following conditions and wait for at least 2 seconds: - CVT selector lever is in the P position.

- Depress the brake pedal.

2. Check “Self Diagnostic Result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-466, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK DTC WITH IPDM E/R

Check “Self Diagnostic Result” with CONSULT-III. Refer to PCS-45, "DTC Index".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace malfunctioning parts.

2.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> Inspection End.

    B2557 vehicle speed
    Description BCM receives the 2 vehicle speed signals via CAN communication. One signal is transmitted by the “unified meter”. Another signal is transmitted by “ABS actuator and electric unit ...

    B2601 shift position
    Description BCM confirms the shift position with the following 2 signals. • CVT selector lever • P position signal from IPDM E/R (CAN) DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26 ...

    Other materials:

    Input shaft and gear
    Exploded View Refer to TM-28, "Exploded View". Disassembly 1. Before disassembling, measure end play for 3rd, 4th, 5th, and 6th input gears. End play standard value : Refer to TM-83, "End Play". 2. Remove oil channel. 3. Press out input shaft rear bearing using Tool an ...

    P1805 Brake switch
    Description Brake switch signal is applied to the ECM via the stop lamp switch when the brake pedal is depressed. This signal is used mainly to decrease the engine speed when the vehicle is being driven. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION ...

    Air breather hose
    Exploded View 1. Air breather hose 2. Clip 3. Bracket 4. Air breather tube 5. CVT assembly A. Paint mark Removal and Installation Refer to the figure for removal and installation. CAUTION: • Install air breather hose with paint mark facing upward. • Insert air breather hose a m ...