Nissan Altima (L32) 2007-2012 Service Manual: Blower motor
Removal and Installation
REMOVAL
1. Remove the glove box. Refer to IP-12, "Removal and Installation".
2. Disconnect the blower motor connector (1).
3. Remove the three blower motor screws (A) and remove the
blower motor from the blower unit.
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
COMPONENTS
1. Heater and cooling unit
2. Blower unit
Front
REMOVAL
1. Remove the heater and cooling unit assembly. Refer to VTL-12, "Removal and
Installation&q ...
Removal and Installation
The fan control amplifier is part of the blower motor. Refer to VTL-15,
"Removal and Installation". ...
Other materials: Changing engine oil and oil filter
For additional information on engine oil
and oil filter change, refer to the instructions
outlined in this section.
Vehicle set-up
1. Park the vehicle on a level surface and
apply the parking brake.
2. Run the engine until it reaches operating
temperature.
3. Turn the engine off and wait for 15 mi ...
Front manual seat adjustment
(if so equipped)
Your vehicle seats can be adjusted manually.
For additional information about adjusting
the seats, refer to the steps outlined
in this section.
WARNING
Before driving the vehicle, return the
seatback to an upright seating position
after manually releasing it. Also, make
sure the seat is locked in p ...
System temporarily unavailable
For vehicles with the 7 inch (18 cm) display
Condition A
When the radar sensor picks up interference
from another radar source, making it
impossible to detect a vehicle ahead, the
I-FCW system is automatically turned off.
The AEB with Pedestrian Detection system
warning light (yellow) will illumin ...