Nissan Altima 2007-2012 Service Manual: CVT Position
Inspection and Adjustment
INSPECTION
1. Place selector lever in “P” position, and turn ignition switch ON (engine stop).
2. Make sure that selector lever can be shifted to other than “P” position when brake pedal is depressed.
Also make sure that selector lever can be shifted from “P” position only when brake pedal is depressed.
3. Move the selector lever and check for excessive effort, sticking, noise or rattle.
4. Confirm the selector lever stops at each position with the feel of engagement when it is moved through all the positions. Check that the actual position of the selector lever matches the position shown by the shift position indicator and the manual lever on the transaxle.
5. The method of operating the selector lever to individual positions correctly should be as shown.
6. When selector button is pressed in “P”, “R”, or “N” position without applying forward/backward force to selector lever, check button operation for sticking.
7. Confirm the back-up lamps illuminate only when selector lever is placed in the “R” position. Confirm the back-up lamps do not illuminate when the selector lever is pushed toward the “R” position when in the “P” or “N” position.
8. Confirm the engine can only be started with the selector lever in the “P” and “N” positions.
9. Make sure transaxle is locked completely in “P” position.
10. When selector lever is set to manual shift gate, make sure that manual mode is displayed on combination meter.
Shift selector lever to “+” and “-” sides, and check that set shift position changes.
ADJUSTMENT
CAUTION: Apply parking brake before adjustment.
1. Loosen the control cable nut.
2. Place the manual lever and the selector lever in “P” position.
3. Tighten control cable nut to specified torque.
Control cable nut: Refer to TM-256, "Exploded View".
CAUTION: Secure the manual lever when tightening control cable nut. Make sure the manual lever stays in the "P" position.
4. Check the operation of the CVT.
Road test
Description
DESCRIPTION
• The purpose of the test is to determine overall performance of CVT
and analyze causes of problems.
• The road test consists of the following three parts:
1. “Che ...
On-vehicle repair
TRANSMISSION CONTROL MODULE
Exploded View
1. TCM
2. Bracket
3. Battery
Removal and Installation
REMOVAL
1. Disconnect the battery negative terminal. Refer to PG-139, "Removal and
I ...
Other materials:
Front seat
Exploded View
DRIVER'S SEAT
1. Headrest
2. Headrest holder (locked)
3. Headrest holder (free)
4. Seatback board
5. Seatback assembly
6. Slide cover
7. Seat belt buckle
8. Seat harness
9. Seat cushion heater unit
10. Seat cushion
11. Seat trim
12. Front leg covers
13. Seat cushion fr ...
Exterior front
1. Power windows
2. Windshield
3. Windshield wiper and washer switch
4. Engine hood
5. Tie down
6. Fog light switch (if so equipped)
7. Headlight and turn signal switch
8. Replacing bulbs
9. Tire pressure
10. Flat tire
11. Tire chains
12. Mirrors
13. Door locks, NISSAN Intelligen ...
P0462, P0463 Fuel level sensor
Description
The fuel level sensor is mounted in the fuel level sensor unit.
The sensor detects a fuel level in the fuel tank and transmits a signal to the
combination meter. The combination
meter sends the fuel level sensor signal to the ECM via the CAN communication
line.
It consists of ...